3m headset manual

including a headset that is sent back to 3M for repair. The repaired headset would have to be registered again at a later date. 1. Enter the base station configuration mode. 2. Select 04 Registration 2 Remove Headsets. 3. Scroll to the number of the headset you want to un-register. 4. Press Enter. 3M approved units acceptable for use in this system to avoid system function safety concerns. • The 3M™ Drive-thru Headset Battery Charger, G5 slot and the 3M™ Drive-Thru Headset Charging Station, G5 are sup plied with two power connections to allow for connecting an additional charger and/or base station. 3M ™ / Manual Listen (ML) • Headset beeps when vehicle is detected • Tap Talk button to turn on Customer Order Point microphone and hear the customer • Customer Order Point microphone stays on until vehicle departs Push To Talk (PTT).

3M ™ WorkTunes Hearing Protector User Guide 4 At-A-Glance Buttons/knobs Recessed input jack - Intuitive to use - Contemporary design Soft padding For extended comfort Voice Assist - Makes programming and controlling the headset easier - Change radio stations or MP3 tracks, without needing to remove the headset - Indicates low battery. 3M TM PELTOR ProTac III Slim Headset MT13HP3E 3M TM PELTOR ProTac III Headset MT13HP3E SLC 80 32 Class 5 Clamping Force 11,3N Mass g AS/NZS The 3M Programming Station Swing the microphone to one side until it reaches the built-in stop. ESS 3M C Headset Programming Procedure ESS, Inc. -- 3M C Headset - Programming Page 2.

Note: The operating temperature range for the G5 Headset should be between +5 °C and +50 °C XT-1 Headsets Overview This chapter provides instructions for using headsets with an 3M™ Wireless Communication System Model XT-1 after the system has been installed, configured, and powered on. 3M approved units acceptable for use in this system to avoid system function safety concerns. • The 3M™ Drive-thru Headset Battery Charger, G5 slot and the 3M™ Drive-Thru Headset Charging Station, G5 are sup plied with two power connections to allow for connecting an additional charger and/or base station. including a headset that is sent back to 3M for repair. The repaired headset would have to be registered again at a later date. 1. Enter the base station configuration mode. 2. Select 04 Registration 2 Remove Headsets. 3. Scroll to the number of the headset you want to un-register. 4. Press Enter.